Spectra 20K Library User Guide - Spectra Logic
Spectra 20K Library User Guide - Spectra Logic
Spectra 20K Library User Guide - Spectra Logic
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 2. Partitioning and Configuring the <strong>Library</strong><br />
Saving Ethernet Parameters<br />
Before any configuration changes can take effect it is necessary to reset the G2 E-QIP<br />
board. This can be accomplished through the <strong>Library</strong> Controller. Configuration changes<br />
that require a reset include:<br />
•When any Ethernet parameter is changed.<br />
•When an Ethernet protocol is enabled or disabled.<br />
•When a library partition is modified.<br />
•When any protocol configuration parameter is changed.<br />
•When any port mapping or target visibility is changed.<br />
Reset the G2 E-QIP<br />
To reset the G2 E-QIP follow the following procedure:<br />
1. From the Maintenance Toolbar select Diagnostic (Figure 2-20).<br />
o<br />
Figure 2-20 The <strong>Library</strong> Diagnostic seen.<br />
46