MCH 6 EM Explorer Nitrox - Submarine Manufacturing and Products ...

More documents

Recommendations

Info

7.2 Indication and control devices The “MCH 6 EXPLORER NITROX” series of refill stations are fitted with some devices to control the discharge of condensation, the cleaner filter and the lubrication oil level (Fig.51). 1 Pressure gauge It indicates the working pressure. DA VERIFICARE 51 2 Strainer filter The purpose of this device is to withhold the impurities present in the air before they enter the cylinders. 3 Condensate discharge taps They enable the condensate that has accumulated during machine operation to be discharged by hand. The condensate is discharged automatically by the machine by means of electromagnetically-controlled valves. 40 Control panel
START AND STOP 8 This chapter describes the operations regarding the machine start up phase. The following instructions presume that the operator has already become familiar with the precautions given in Chapter 4 “Precautions for use and maintenance” and that the machine has been installed according to the instructions given in the previous chapter. 8.1 Filling the machine ............................................................................................................ 41 8.2 Checks ................................................................................................................................ 43 8.2.1 Models with electric power supply ........................................................................... 43 8.2.2 Models with petrol supply ........................................................................................ 45 8.2.3 Calibrate analyzer ..................................................................................................... 49 8.2.4 Stop ........................................................................................................................... 50 Filling the machine 8.1 WARNING Before proceeding with the start up operations described below, read chapter 4, “Precautions for use and maintenance” very carefully and follow the advice given. Fill the lubricating oil sump of the pump unit when the machine is switched off. The machine is delivered without lubricating oil which is collected in the cans that can be found inside the machine packaging (Fig.52). 52 Start and stop 41
Page 1 and 2: Special equipment and compressors f
Page 3 and 4: UNPACKING AND HANDLING THE MACHINE
Page 5 and 6: REGISTERS 13 13.1 Machine log book
Page 7 and 8: USE IN BRIEF The following informat
Page 9 and 10: GUARANTEE AND ASSISTANCE 1 Guarante
Page 11 and 12: The “MCH 6 EXPLORER NITROX” ser
Page 13 and 14: Description of the pump unit 2.2 Th
Page 15 and 16: The 3 rd stage is made of special s
Page 17 and 18: Lubricating unit 2.2.4 Lubrication
Page 19 and 20: Frame 2.2.8 The compressor and the
Page 21 and 22: Caratteristiche tecniche “MCH6”
Page 23 and 24: Noise 3.2 The “MCH 6”series of
Page 25 and 26: Machine area diagrams 4.1 The “MC
Page 27 and 28: Table 1 POSITION SAFETY DEVICE DESC
Page 29 and 30: UNPACKING AND HANDLING THE MACHINE
Page 31 and 32: INSTALLATION 6 This chapter provide
Page 33 and 34: CAUTION Only use a flexible pipe pr
Page 35 and 36: Connecting the refill hoses 6.2.2 1
Page 37 and 38: CONTROL PANEL 7 This chapter provid
Page 39: Controls on board the internal comb
Page 43 and 44: If the oil level is low, top it up
Page 45 and 46: If the direction of rotation does n
Page 47 and 48: Move the fuel lever to the “OPEN
Page 49 and 50: Check the level of the pump unit lu
Page 51 and 52: 78 then release the condensate usin
Page 53 and 54: USE 9 This chapter describes the op
Page 55 and 56: Refilling the cylinders 9.2 During
Page 57 and 58: The nitrox percentage can now be re
Page 59 and 60: The place where the refill station
Page 61 and 62: Disposal of waste products 10.2 Whe
Page 63 and 64: MAINTENANCE 11 This chapter include
Page 65 and 66: Changing the lubricant oil 11.3 The
Page 67 and 68: Disassembling the belt to be replac
Page 69 and 70: Active carbon filter and molecular
Page 71 and 72: Intake and discharge valves 11.8 Th
Page 73 and 74: Screw up the oil discharge cap agai
Page 75 and 76: Move the fuel valve to “CLOSE”
Page 77 and 78: Minimum carburettor regulation 11.1
Page 79 and 80: Check of the safety valve 11.12.1 T
Page 81 and 82: TROUBLESHOOTING 12 This chapter des
Page 83 and 84: REGISTERS 13 This chapter deals wit
Page 85 and 86: Compression diagram - only air 14.2
Page 87 and 88: SPARE PARTS 15 15.1 Exploded view o
Page 89 and 90: Pumping unit POSIZ. CODICE DESCRIZI
Page 91 and 92:
MCH 6/EM EXPLORER NITROX and MCH 6/
Page 93 and 94:
MCH 6/SH EXPLORER NITROX cooling pl
Page 95 and 96:
Active carbon filter and condensate
Page 97 and 98:
Controls 16.2 The analyser has an i
Page 99 and 100:
Troubleshooting 16.6 SYMPTOM REASON
Page 101 and 102:
Information on handling of the sens
show all

MCH 6 EM Explorer Nitrox - Submarine Manufacturing and Products ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?