MCH 6 EM Explorer Nitrox - Submarine Manufacturing and Products ...

The oil will have to be filled after removing the cap
(Fig.53).
The quantity of oil to be poured in is 1.5 lt. and the
level should be checked with the machine turned
off, bearing in mind that an excess amount of oil
may cause infiltrations in the cylinders and a
deposit on the valves. On the contrary, if the oil
level is too low, the tang of the connecting rod is
prevented from providing the correct lubrication
with the possibility of causing a seizure of the
cylinders.
To check the amount of oil added, see the next
paragraph.
When the operation has been completed, screw
the cap up again.
53
MODELS WITH INTERNAL CONBUSTION ENGINES
For models run by internal combustion engines, the level of the engine oil must be checked.
CAUTION
If the engine is run with an insufficient level of oil, it may be irreparably damaged. Check the oil level on
a flat surface with the engine off.
Remove the oil cap and clean the dipstick
(Fig. 54).
Insert the dipstick in the oil refill hole without
screwing it down.
54
Remove the dipstick and check the level (Fig. 55).
55
42
Start and stop