Gaymar FW600 Operator's Manual
Gaymar FW600 Operator's Manual
Gaymar FW600 Operator's Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ENGLISH<br />
REMOVE FROM USE<br />
indicator<br />
STANDBY<br />
indicator<br />
SETPOINT switch<br />
button<br />
IV pole clamp<br />
RUN /STANDBY<br />
switch<br />
Cassette slot<br />
Bubble trap<br />
receiver<br />
Figure 1—<strong>FW600</strong> series Blood/Fluid Warmer<br />
2.0 Product Description<br />
The Medi-Temp III <strong>FW600</strong> Series Blood/Fluid Warmer<br />
is a dry-heat device designed for safe and rapid<br />
warming of blood, blood products and other fluids<br />
through the utilization of disposable blood/fluid<br />
warming sets. The warmer does not provide fluid flow<br />
rate control. Blood, blood products and other fluids<br />
normally refrigerated, can be rapidly warmed to user<br />
selectable temperatures of between 38.0°C–43.0°C<br />
at flow rates up to 300 ml/min. Room temperature<br />
fluids can be warmed at flow rates up to 500 ml/min.<br />
The disposable Blood/Fluid warming sets are available<br />
in Standard, Standard with Extensions, Pediatric, and<br />
High Flow models.<br />
2.1 Warmer<br />
The warming unit is designed to be IV pole<br />
mounted. The device has no on/off switch.<br />
Connection to the AC supply is indicated by a<br />
green STANDBY mode indicator, located on the<br />
front panel. In STANDBY mode, no power can be<br />
applied to the heater. To begin normal operation,<br />
the RUN/STANDBY button must be pressed.<br />
When this occurs, an LED temperature display located<br />
on the front panel will display the actual fluid<br />
temperature or the setpoint temperature in °C.<br />
The setpoint is user selectable from 38.0°C–43.0°C<br />
in 1.0°C increments, by use of the SETPOINT switch on<br />
the front panel. Also located on the front of the unit is<br />
a slot for insertion of the disposable warming set. On<br />
the right side of the unit, just below the IV pole clamp,<br />
is a receiver for the disposable warming set’s bubble<br />
trap.<br />
2.2 Disposable sets<br />
The Medi-Temp III <strong>FW600</strong> Series Blood/Fluid warming<br />
unit is designed to be used only with <strong>Gaymar</strong> D25000<br />
series disposable warming sets. The following warming<br />
sets (figure 2) are designed for use up to 300 mm Hg<br />
pressure. Contact your local dealer for more<br />
information.<br />
2