BAMBI BUCKET SERVICE MANUAL - SEI Industries Ltd.
BAMBI BUCKET SERVICE MANUAL - SEI Industries Ltd.
BAMBI BUCKET SERVICE MANUAL - SEI Industries Ltd.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 4: Making Adjustments<br />
Adjusting Various Components<br />
Section 4: Making Adjustments<br />
Adjusting Various Components<br />
Adjusting the Dump Valve Udder<br />
Udder refers to the amount that the dump valve bulges out<br />
below the bucket shell, when the bucket is full. Dump valve<br />
udder adjustment has a significant effect on the valve seal<br />
between the fabric dump valve itself and the bucket shell. This<br />
adjustment is carried out by lengthening or shortening the<br />
tripline adjustment chain.<br />
Ninety percent of the dump valve seal is produced by the<br />
stainless steel bolts passing through the neoprene foam and the<br />
bucket. The balance of the sealing action is a result of the valve<br />
“uddering” out the bottom of the bucket and compressing the<br />
foam between the valve and the bucket.<br />
Exposed Udder<br />
A properly adjusted dump valve will have a maximum of 2" (50 mm) of udder. Too much udder will add to<br />
the volume and thus the weight of the bucket. Too little udder will prevent the secondary sealing action and<br />
will result in the valve leaking.<br />
Adjusting the Udder via the Tripline<br />
Each new Bambi bucket is adjusted and checked at the<br />
factory under full fill for proper dump valve adjustment.<br />
To adjust the udder, change the length of the tripline by<br />
adjusting it at the tripline adjustment chain.<br />
The method of securing the ring and riser is to secure the<br />
adjustment chain to a shackle that is attached to the<br />
tripline.<br />
If a new tripline is installed, first install it at the same<br />
point on the adjustment chain and then test the dump<br />
valve in use. Remember to secure the adjustment<br />
shackle with a lockwire or tie wrap first. It is impossible<br />
to judge udder with an empty bucket on the ground.<br />
Control head<br />
Tripline<br />
Ring and riser<br />
adjustment<br />
chain<br />
We Engineer Solutions<br />
Bambi Bucket Service Manual – Models 5566-HL9800 (Version D) 13