BAMBI BUCKET SERVICE MANUAL - SEI Industries Ltd.
BAMBI BUCKET SERVICE MANUAL - SEI Industries Ltd.
BAMBI BUCKET SERVICE MANUAL - SEI Industries Ltd.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 4: Making Adjustments<br />
Adjusting Various Components<br />
To adjust a single line:<br />
1. Simply adjust the tension of the line to equal that of adjacent<br />
lines. Repeat the knot shown three times for each purse string.<br />
To adjust all the lines:<br />
1. Stand the bucket vertically.<br />
2. With the valve bottom flat on the floor, pull the bucket shell into a<br />
round shape by deploying the IDS.<br />
3. Run a rope from an overhead support to the ring on the top of the<br />
valve.<br />
4. Proceed to adjust the string.<br />
Checking Purse Line Adjustment<br />
Once the lines are adjusted, fill the Bambi bucket with water,<br />
just below the top of the valve. Check to see if both lips of the<br />
valve are matched right across the top. Sometimes, one lip will<br />
‘track’ slightly above or below the other.<br />
Usually, one or two specific purse lines will cause this improper<br />
tracking. To correct:<br />
1. Grasp the purse lines at the centre of the lower side.<br />
2. Pull the strings several times to bring the lip into<br />
alignment.<br />
3. Re-tie the purse lines so that the line is just snug. Do<br />
not over-tension the line. Over-tensioning will result<br />
in misalignment at another position on the valve.<br />
One side lip is raised due to incorrect<br />
purse line adjustment.<br />
We Engineer Solutions<br />
Bambi Bucket Service Manual – Models 5566-HL9800 (Version D) 15