Owners Manual - AquaCal
Owners Manual - AquaCal
Owners Manual - AquaCal
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Page 34<br />
FAULT CODE RULE OUT RESOLUTION<br />
Water Pressure<br />
Switch<br />
incorrectly<br />
calibrated<br />
STEP 3:<br />
See section entitled “Water Flow (Pressure) Switch<br />
Adjustment” on page 20.<br />
STEP 4:<br />
Call heat pump installer or <strong>AquaCal</strong> AutoPilot<br />
Customer Support for further assistance.<br />
“CSE” Indicator<br />
Control system error.<br />
“CEr” Indicator<br />
Communication fault.<br />
Defective control<br />
board<br />
Loose or<br />
damaged cable<br />
STEP 1:<br />
Disconnect then reconnect power to reset control. If<br />
error recurs, proceed to next step.<br />
STEP 2:<br />
Control board requires replacement. If error recurs,<br />
proceed to next step.<br />
STEP 3:<br />
Call heat pump installer or <strong>AquaCal</strong> AutoPilot<br />
Customer Support for further assistance.<br />
STEP 1:<br />
Check “Cat5” cable from control board to display<br />
assembly.<br />
STEP 2:<br />
Call heat pump installer or <strong>AquaCal</strong> AutoPilot<br />
Customer Support for further assistance.<br />
Table 14