VDO Marine - Howard Instruments
VDO Marine - Howard Instruments
VDO Marine - Howard Instruments
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Special Application Devices<br />
Signal Amplifiers, Multiplier & Dividers<br />
P/n 411.110<br />
Signal interface<br />
The <strong>VDO</strong> Signal Amplifier/Divider is a general purpose module designed to convert the signal<br />
from square wave to sine wave and vice versa.<br />
It can divide as well as multiply the frequency in small steps up to three times plus or minus.<br />
Ideal for calibrating electronic boat speedo or tachometers.<br />
12/24V<br />
P/n 410.020<br />
Tachourmeter active signal filter<br />
The <strong>VDO</strong> active filter can reduce the effect of electrical noise mixed with signal.<br />
This is in situation when the electrical interference is excessive and the speedo<br />
or tacho have a pointer fluctuation (erratic reading).<br />
Inputs: Red Battery +12/24V, Orange Ignition + 12/24V, Green Signal Input, Blue Signal Output<br />
Note: Connector IN & OUT made to suit the <strong>VDO</strong>, Vision & International Tachourmeter<br />
12/24V<br />
P/n 411.096<br />
Tachometer inductive sender, signal amplifier/Frequency Divider<br />
The <strong>VDO</strong> Signal Amplifier/Divider is a general purpose module designed to work with most<br />
speedometer and tachometer signals. This box will amplify a low voltage signal to a 10V peak to<br />
peak square wave. This can be useful when a signal is too low to drive a speedometer, tacho,<br />
cruise control or any other such device. The signal may also be divided in frequency by a factor<br />
of 1, 2, 4, 8 or 16 to allow easier integration to another instrument.<br />
12/24V<br />
P/n 411.101<br />
Over-Rev switch with two independent channels<br />
A microprocessor controlled electronic switch module that can be programmed for a number of<br />
different functions. With two separate signal inputs switching two separate 5A relays contact the<br />
module can be a number of functions’ combination. RPM, Speed Shaft rotation monitoring.<br />
12/24V<br />
70