1:10 SCALE 2WD ELECTRIC PRO RACING TRUCK - Absima
1:10 SCALE 2WD ELECTRIC PRO RACING TRUCK - Absima
1:10 SCALE 2WD ELECTRIC PRO RACING TRUCK - Absima
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Transmitter Preparation<br />
Power Switch<br />
Antenna<br />
27MHzTransmitter Crystal (TX)<br />
ON<br />
Extend the antenna to the maximum<br />
Length for best performance<br />
Transmitter crystal(TX)<br />
Receiver crystal(RX)<br />
OFF<br />
The crystal can be replaced to change frequencies.<br />
Note : You must also change receiver crystals!<br />
Do not use AM crystals<br />
Battery Level Indicator<br />
Good Batteries<br />
Low Batteries(Light Blinks)<br />
Left turn<br />
Straight (neutral)<br />
Right turn<br />
1<br />
Steering Trim<br />
3<br />
1<br />
Reverse Switch<br />
反 向 开 关<br />
Servo Factory Settings<br />
DIGITAL<br />
<strong>PRO</strong>PORTIONAL<br />
RADIO CONTROL<br />
SYSTEM<br />
2<br />
To be used for trimming the steering<br />
operation<br />
4<br />
Brake<br />
2<br />
Throttle Trim<br />
Forward<br />
Stop(Neutral)<br />
DIGITAL<br />
<strong>PRO</strong>PORTIONAL<br />
RADIO CONTROL<br />
SYSTEM<br />
To be used for throttle operation<br />
Throttle Trigger<br />
To be used for trimming the throttle<br />
operation<br />
4<br />
3ch Switch<br />
3<br />
Steering Dual Rate<br />
This switch is used for optional parts.<br />
To be used to adjust steering servo throw<br />
Transmitter Battery Installation<br />
Open battery cover at the bottom of transmitter.<br />
Install batteries. Follow the direction of batteries<br />
designated in the inside of battery box.<br />
Battery Cover<br />
8X<br />
AA Alkaling Batteries
Change language