Ultra Sauna Gas Heater - Scandia Manufacturing
Ultra Sauna Gas Heater - Scandia Manufacturing
Ultra Sauna Gas Heater - Scandia Manufacturing
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Back Panel Assembly Rough-in for 40,000 BTU heaters<br />
To prepare or rough-in for your Am-Finn <strong>Ultra</strong>-<strong>Gas</strong> sauna heater, you must consider two area<br />
for rough-in. 1) the exhaust and air intake vents must be roughed-in through the wall extending<br />
to the outside. 2) the interior room cedar walls must be roughed-in to accommodate the<br />
back panel of the heater. NOTE: you must consult local code for all type B gas venting regulations<br />
and other gas appliance regulations before installing. Unit must be installed by a certified<br />
professional.<br />
20 1/4”<br />
Back Panel<br />
6 1/4”<br />
Through-wall rough-in.<br />
A) Exhaust vent (W 9 1/2 in x H 9 1/2<br />
in)<br />
B) Intake vent (W 13 3/4 in x H 6 in)<br />
(These measurements may vary due to difference in<br />
production runs).<br />
5 1/2”<br />
A<br />
Exhaust Vent<br />
9 1/2” x 9 1/2”<br />
5 1/2”<br />
32 1/4”<br />
8 1/4”<br />
20”<br />
1 1/2”<br />
B<br />
Air Intake Vent<br />
W 13 3/4 x H 6”<br />
5 1/4”<br />
3 ”<br />
3 1/2”<br />
floor<br />
Back Panel Rough-in - Back panel dimensions are<br />
W 20 1/2” x H 32 1/2”. When lining room with<br />
cedar, do not apply cedar to these specified back<br />
panel dimensions. This 20 1/4 and 32 1/4 in<br />
rough-in should be placed 3” from the floor.<br />
20 1/4”<br />
Cedar <strong>Sauna</strong> Wall<br />
Behind Cedar Wall Surface<br />
32 1/4”<br />
Through-wall rough-in<br />
(see above)<br />
6