MC55i AT Command Set

MC55i AT Command Set
11.9 AT+CGQMIN
11.9 AT+CGQMIN Quality of Service Profile (Minimum acceptable)
Syntax
Test Command
AT+CGQMIN=
Response(s)
+CGQMIN: , (list of supported s), (list of supported s), (list of
supported s), (list of supported s), (list of supported s)
OK
ERROR
+CME ERROR:
Read Command
AT+CGQMIN
Response(s)
[+CGQMIN: , , , , , ]
[+CGQMIN: ...]
OK
ERROR
+CME ERROR:
Write Command
AT+CGQMIN=[[, [, [, [, [, ]]]]]]
Response(s)
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last Reference(s)
+ + + + + + - - - GSM 07.07
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context. If no minimum profile was explicitly
specified for a context, simply OK will be returned, but default values will be used for that context.
This command allows the TE to specify a minimum acceptable profile which is checked by the MT against the
negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local) context identification parameter,
.
A special form of the set command, AT+CGQMIN= causes the minimum acceptable profile for context
number to become undefined. In this case no check is made against the negotiated profile.
AT&F and ATZ will undefine the minimum QoS profiles of every context which is not active or not online.
Parameter Description
(num)
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
MC55i_ATC_V01.201 Page 285 of 482 1/14/09
Confidential / Released