REQUEST FOR PROPOSALS - DDC Document Exchange - NYC.gov

More documents

Recommendations

Info

5.08.1 MEASUREMENT FOR PAYMENT (SKETCH OF SURVEY LIMITS FOR SEWER AND WATER MAIN SURVEY) A. For continuous run projects along a single direction, the pay length in linear feet will be measured along the longitudinal route of the project as shown below. The area shall extend up to 50 LF. beyond the R.O.W. in all directions including extending line in the side streets intersections. The sketch below shows the payment length. B. For projects extending over multiple intersecting streets, the pay length in linear feet will be measured along the longitudinal route of the project. The Topographical map and the Profile, along these overall pay lengths shall be shown in the drawings (with intersections being duplicated on overlapping drawings), and the cost of which is deemed included in the unit price for the survey and drafting work. The sketch shown below is for a typical project and the payment measurements are shown. _______________________________________________________________________________ CITY OF NEW YORK PROFESSIONAL SERVICES DEPARTMENT OF DESIGN AND CONSTRUCTION REQUIREMENTS CONTRACT JULY 2011 54
C. For unit price item No. 4 the longitudinal length per project shall be based on a street right-of-way width of 100’ or less. For street right-of-way widths greater than 100’, payment per unit price will be adjusted by adding 1% for each additional foot of street right-of-way width above 100’, to the nearest foot. For example, a project with a 150’ width for the street right-of-way will be paid at 150% of the unit price for that portion of the project area ONLY. SECTION 6 UNIT PRICE ITEM NO. 5 6.01 PREPARATION OF SURVEY DOCUMENTS FOR HIGHWAY, SEWER, AND WATER MAIN PROJECTS Under this item of the contract work, the Consultant shall provide all surveying services necessary and required to produce the following deliverables: (1) Topographical Plan Map(s); (2) Clean Base Map(s); (3) Composite Utility Plan and Profile Map(s); (4) Highway Profile(s); and (5) Survey Control Map(s) for Highway Projects and/or Sewer and Water Main Projects. All work under this unit item shall be done in accordance with the general requirements in Section 1 and the following requirements. 6.02 SURVEY REQUIREMENTS AND INFORMATION TO BE OBTAINED AND SHOWN ON THE MAPS The Consultant shall follow the below mentioned parameters: A. The Topographical Plan Map(s) shall locate all physical features within the project limits in plan view needed to produce drawings (or maps) including, but not limited to requirements described in Section 1.07. The project limits shall include the entire area of the work as illustrated in section 5.08.1 which includes areas 50 feet beyond the street right of way lines, or as directed by the Commissioner. B. A stationed centerline shall be provided and tied to possession and/or R.O.W. lines. Where there are intersecting streets, the station lines (centerline of ROW) shall show the intersection of the two station lines and clearly be labeled with appropriate stationing. _______________________________________________________________________________ CITY OF NEW YORK PROFESSIONAL SERVICES DEPARTMENT OF DESIGN AND CONSTRUCTION REQUIREMENTS CONTRACT JULY 2011 55
Page 1 and 2:
REQUEST FOR PROPOSALS PIN Project P
Page 3 and 4:
PROJECT: PW311STLS PIN: 8502011RQ00
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Tax ID #: PIN #: 8502011RQ0008P-12P
Page 41 and 42:
Tax ID #: PIN #: 8502011RQ0008P-12P
Page 43 and 44:
ATTACHMENT 7 DOING BUSINESS DATA FO
Page 46:
Page 4 of 2
Page 50 and 51:
THIS AGREEMENT, made and entered in
Page 52 and 53:
ARTICLE 2 General Provisions 2.1 Ge
Page 54 and 55: (e) Total estimated amount for all
Page 56 and 57: 6.6 Non-Reimbursable Services: Thro
Page 58 and 59: preparation of all required Survey
Page 60 and 61: Consultant has not yet performed, a
Page 62 and 63: is issued by the Commissioner durin
Page 64 and 65: elow, unless the Contractor has obt
Page 66 and 67: (j) (k) the purposes of the Contrac
Page 68 and 69: ACKNOWLEDGMENT BY CORPORATION State
Page 70 and 71: EXHIBIT B UNIT PRICES AND ALL INCLU
Page 72 and 73: SECTION C - EDUCATION REQUIREMENTS
Page 74 and 75: TECHNICAL REQUIREMENTS FOR SURVEYIN
Page 76 and 77: The Consultant shall provide all su
Page 78 and 79: Benchmarks - One Permanent Benchmar
Page 80 and 81: B. Any elevation or dimension taken
Page 82 and 83: 6. All curb types must be depicted
Page 84 and 85: D. All Survey Documents shall be cl
Page 86 and 87: have been extended, or, if the Cons
Page 88 and 89: Under this item of the contract, th
Page 90 and 91: 4. The representation shall be as f
Page 92 and 93: special conditions and situations s
Page 94 and 95: A. Procedure: The procedure for sub
Page 96 and 97: I. The Consultant shall also supply
Page 98 and 99: 4.05.1 MEASUREMENT FOR PAYMENT (SKE
Page 100 and 101: SECTION 5 UNIT PRICE ITEM NO. 4 5.0
Page 102 and 103: Profile shall be 1”=30’ Horizon
Page 106 and 107: C. All elements of the Topographic
Page 108 and 109: A. The Composite Utility Plan and P
Page 110 and 111: Survey Documents in the Final Submi
Page 112 and 113: etc.) Design Files (See Description
Page 114 and 115: 9.03.2 Marker Illustration Survey m
Page 116: 9.03.4 Horizontal Controls The Cons
Page 132 and 133: Section 4.07 Non-Discrimination: E.
Page 134 and 135: Section 12.05 No Claim Against Offi
Page 136 and 137: Appendix A December 2010 Final betw
Page 138 and 139: Appendix A December 2010 Final D. T
Page 140 and 141: Appendix A December 2010 Final Sect
Page 144 and 145: Appendix A December 2010 Final D. T
Page 146 and 147: Appendix A December 2010 Final F. A
Page 150 and 151: Appendix A December 2010 Final E. I
Page 152 and 153: Appendix A December 2010 Final prio
Page 154 and 155:
Appendix A December 2010 Final B. I
Page 156 and 157:
Appendix A December 2010 Final Sect
Page 158 and 159:
Appendix A December 2010 Final agre
Page 160 and 161:
Appendix A December 2010 Final term
Page 162 and 163:
Appendix A December 2010 Final B. A
Page 164 and 165:
Appendix A December 2010 Final Cont
Page 166 and 167:
Appendix A December 2010 Final AFFI
show all

REQUEST FOR PROPOSALS - DDC Document Exchange - NYC.gov

Create successful ePaper yourself

Delete template?

Save as template?