You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SPRITE VALVES<br />
Single Sub-base Mounting<br />
Between the valve and the sub-base is a locating pin which assures accurate<br />
alignment of valve and sub-base. Valves are secured with two mounting screws.<br />
The mounting of this valve may be achieved by one of two methods:<br />
1. Sub-base may be bulkhead mounted using 1/4-20 threaded mounting holes<br />
on the bottom of the sub-base.<br />
2. The same holes are counter-bored from the top of the sub-base to accept #8<br />
screws for surface mounting.<br />
Valves and sub-bases may be ordered separately; however, factory assembly is<br />
available at a nominal charge.<br />
CHART A<br />
Port Identification<br />
Operation 1 2 3 4<br />
3-Way Normally Open Inlet Exhaust Cylinder -<br />
3-Way Normally Closed Exhaust Inlet Cylinder<br />
3-Way Diverter Cylinder Cylinder Inlet -<br />
4-Way Common Exhaust Inlet Exhaust N.C.<br />
Cylinder<br />
N.O.<br />
Cylinder<br />
CHART B<br />
Sub Base Porting<br />
Base Model #<br />
3-Way 4-Way Description<br />
231S 241S Side Ported, 1/8 NPT<br />
232S 242S Side Ported 1/4 NPT<br />
231B 241B Bottom Ported 1/8 NPT<br />
232B 242B Bottom Ported 1/4 NPT<br />
17