PowerFlex 700 AC Drives

POWER TERMINAL RATINGS
WIRE RANGE: 14-1/0 AWG (2.5-35 MM 2 )
TORQUE: 32 IN-LB (3.6 N-M)
STRIP LENGTH: 0.67 IN (17 MM)
USE 75 C CU WIRE ONLY
17
GROUND TERMINAL RATINGS (PE)
WIRE RANGE: 6-1/0 AWG (16-35 MM 2 )
TORQUE: 44 IN-LB (5 N-M)
STRIP LENGTH: 0.83 IN (21 MM)
21
300 VDC EXT PWR SPLY TERM (PS+, PS-)
WIRE RANGE: 22-10 AWG (0.5-4 MM 2 )
TORQUE: 5.3 IN-LB (0.6 N-M)
STRIP LENGTH: 0.35 IN (9 MM)
9
1-8 Installation/Wiring
AC Input Phase Selection (Frames 5 & 6 Only)
!
ATTENTION: To avoid a shock hazard, ensure that all power to the
drive has been removed before performing the following.
Moving the “Line Type” jumper shown in Figure 1.2 will allow single or
three-phase operation.
Important: When selecting single-phase operation, input power must
be applied to the R (L1) and S (L2) terminals only to assure
power to the fan.
Selecting/Verifying Fan Voltage (Frames 5 & 6 Only)
Important: Read Attention statement above!
Frames 5 & 6 utilize a transformer to match the input line voltage to the
internal fan voltage. If your line voltage is different than the voltage class
specified on the drive nameplate, it may be necessary to change
transformer taps as shown below. Common Bus (DC input) drives
require user supplied 120 or 240V AC to power the cooling fans. The
power source is connected between “0 VAC” and the terminal
corresponding to your source voltage (see Figure 1.4).
Table 1.C Fan VA ratings (DC Input Only)
Frame Rating (120V or 240V)
5 100 VA
6 138 VA
Figure 1.2 Typical Locations - Phase Select Jumper & Transformer (Frame 5 shown)
Optional
Communications
Module
3-PH 1-PH
LINE
TYPE
SPARE 1
SPARE 2
Phase Selection
Jumper
Fan Voltage
OUTPUT
INPUT AC
690 Volt Tap
600 Volt Tap
480 Volt Tap
400 Volt Tap
Publication 20B-UM002C-EN-P