EINBAUANLEITUNG / OWNERS MANUAL Einführung ... - Philippi

k SHORE POWER SWITCH OVER UNIT LAE 111
CONNECTION LAE 111
Wire cross section
Wire cross section
4 mm² for power supply
min. 1,5 mm² for outputs A, B, C and D
Power supply mains 230 Volt/50 Hz - shore power
clamp 11 L1 (life - black) Connection of shore power
clamp 12 N (neutral - blue) Connection of shore power
clamp PE PE (protective earth conductor - green/yellow)
Power supply onboard unit 230 Volt/50 Hz - generator/inverter
clamp 11 L1 (life - black) Connection of generator/inverter
clamp 12 N (neutral - blue) Connection of generator/inverter
clamp PE PE (protective earth conductor - green/yellow)
Output A
switched through thermal circuit breaker “Hot Water” - 10A
clamp 21 L1 (life - black) Connection of the water heater
clamp 22 N (neutral - blue) Connection of the water heater
clamp PE PE (protective earth conductor - green/yellow)
Output B
switched through thermal circuit breaker “Battery Charger” - 10A
clamp 31 L1 (life - black) Connection of the battery charger
clamp 32 N (neutral - blue) Connection of the battery charger
clamp PE PE (protective earth conductor - green/yellow)
Output A
switched through thermal circuit breaker “Sockets” - 10A
clamp 21 L1 (life - black) Connection of the sockets
clamp 22 N (neutral - blue) Connection of the sockets
clamp PE PE (protective earth conductor - green/yellow)
Output B
switched through thermal circuit breaker “Air Condition” - 10A
clamp 31 L1 (life - black) Connection of the air condition
clamp 32 N (neutral - blue) Connection of the air condition
clamp PE PE (protective earth conductor - green/yellow)
all outputs are protected by a fault-current circuit breaker RCBo 25 A (30 mA)
Rear View LAE 111
PE 62 61 PE 52 51 PE 42 41 PE 32 31 PE 22 21 PE 12 11
Air Condition
min. 3 x 1,5 mm²
Sockets
min. 3 x 1,5 mm²
Battery Charger
min. 3 x 1,5 mm²
Hot Water
min. 3 x 1,5 mm²
Generat./Inverter
3 x 4 mm²
Shore
3 x 4 mm²
V1.4 - AUG 2013 Page 3