MS510 MONO LEX - Market Point

4514-630, -635, -636
Actions Yes No
Step 5
Check the lift plate on the input tray for damage.
Go to step 11.
Replace the input tray.
Is it free of damage
Step 6
Make sure the MPF pick roller and separator pad are free of debris. Check
for wear or damage.
Are they free of wear or damage
Step 7
Check the MPF gearbox for wear or damage.
Is it free of wear or damage
Step 8
Make sure the front input guide rollers are free of debris. Check for wear
or damage.
Are they free of wear or damage
Step 9
Make sure the redrive rollers are free of debris. Check for wear or damage.
Are they free of wear or damage
Step 10
a Remove the left cover.
b POR into the Diagnostics menu and perform a duplex test:
Diagnostics Menu > Duplex Tests
c Observe the reverse solenoid for proper operation.
Go to step 7.
Go to step 8.
Go to step 11.
Go to step 10.
Go to step 11.
Replace the MPF pick
roller and separator
pad. See “MPF pick
roller removal” on
page 213 and
“Separator pad
removal” on page
221.
Replace the MPF
gearbox. See “MPF
gearbox removal” on
page 171.
Replace the front input
guide. See “Front input
guide removal” on
page 219.
Replace the redrive
assembly. See “Redrive
assembly removal” on
page 243.
Replace the reverse
solenoid. See “Reverse
solenoid removal” on
page 174.
Does it properly operate
Step 11
Make sure the input roller/deskew assembly is free of debris. Check for
wear or damage.
Contact the next level
of support.
Replace the printer.
Are they free of wear or damage
Diagnostic information
50