SOBER dermatome - Humeca

More documents

Recommendations

Info

8 Fig. 9 The cams should come into the two holes (red dots indicate position of cams) Fig. 10 Correct position of the blade - Finally fix the blade cover and check if the cams are still in the holes of the blade (fig. 11). Re-position if necessary. - After fixing the shaft to the head again, the SOBER dermatome is ready for use Fig. 11 Final situation with the blade cover fixed
9 5. Surgery - Before harvesting the skin, the donor site area of the patient is shaved and cleaned with a disinfectant. The skin is then smoothened with paraffin oil or some other lubricant. Note: In case the graft will be harvested prior to the application of the Humeca MEEK grafting method, please do not use any fatty substance to smoothen the skin, as this will prevent adherence of the MEEK grafts to the prefolded gauzes. You can use sterile water or a buffered salt solution instead. - Stretch the skin to be harvested (preferably this is done by an assistant). No wrinkles or folds should be seen and the skin should be completely smooth. - Put the dermatome on the skin at the starting position for cutting under an angle of about 45 o , as shown in fig. 12. Fig. 12 Starting position of the dermatome
Page 1 and 2: SOBER dermatome Instructions for us
Page 3 and 4: 3 1. Introduction The ability to cu
Page 5 and 6: 5 However, this hexagonal tool is a
Page 7: 7 The following procedure describes
Page 11 and 12: 11 - Press the dermatome firmly to
Page 13: 13 10. Ordering info For ordering,

SOBER dermatome - Humeca

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?