PCL 5 Color Technical Reference Manual - Business Support ...

Vertical Rectangle Size (PCL Units)
This command specifies the vertical rectangle size in PCL Units.
? * c # B
The vertical rectangle size is clipped to the bounds of the logical
page. Values greater than the logical page boundary are acceptable;
however, the final output is limited to the printable area of the logical
page. Values outside the range of 0 – 32767 are ignored.
The default rectangle size is 0. Power-up and reset return this value to
the default.
Vertical Rectangle Size (Decipoints)
This command specifies the vertical rectangle size in decipoints.
? * c # V
# = number of PCL Units (valid to 4 decimal places)
# = number of decipoints (valid to 4 decimal places)
The vertical rectangle size is clipped to the bounds of the logical
page. Values greater than the logical page boundary are acceptable;
however, the final output is limited to the printable area of the logical
page. Values outside the range of 0 – 32767 are ignored.
Decipoints are converted into printer dot values, and any fraction of a
dot is rounded up to the next full printable dot.
The default rectangle size is 0. Power-up and reset return this value to
the default.
EN The PCL Print Model 5-47