PCL 5 Color Technical Reference Manual - Business Support ...

End Raster Graphics Command
The End Raster Graphics command signifies the end of a raster
graphic data transfer.
? * r C
Receipt of this command causes 5 operations:
Resets the raster compression seed row to zeros.
Moves the cursor to the raster row immediately following the
end of the raster area (if a source raster height was specified).
Allows raster commands which were previously locked out to
be processed.
Sets compression mode to 0 (no compression).
Defaults the left graphics margin to X-position 0.
Note This command is a modified version of the ?*rB End Raster
Graphics command. The newer version (?*rC) performs two
additional operations: it resets the compression mode to 0 and
defaults the left graphics margin to 0.
This command (?*rC) is not supported by the HP LaserJet III or the
HP LaserJet IIID printers. Use the ?*rB End Raster Graphics
command to terminate raster graphic data transfers for these printers.
Refer to the “PCL Feature Support Matrix” in Chapter 1 of the PCL 5
Comparison Guide for specific printers which support these
commands.
EN Raster Graphics 6-35