Pet Immune PIR Motion Sensor 1 Introduction: Combined with multi ...
Pet Immune PIR Motion Sensor 1 Introduction: Combined with multi ...
Pet Immune PIR Motion Sensor 1 Introduction: Combined with multi ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Pet</strong> <strong>Immune</strong> <strong>PIR</strong> <strong>Motion</strong> <strong>Sensor</strong> 4<br />
Step 2: according to the function, set the jumpers respectively. Install the battery, and plug the battery<br />
source wires onto the circuit board.<br />
Step 3: close the cover, and adjust the detecting angle.<br />
Signal:<br />
The light flashes 1 time: it initiate.<br />
When it flashes 2 times: the initiate mode finished.<br />
When it flashes 3 times: it detects activities and invasion. It is alarmed and send the alarm report.<br />
When it flashes 10 times: low on battery.<br />
Notice:<br />
- Only one detector can be installed <strong>with</strong>in the same area.<br />
- After replacing the battery or resetting the jumper, it takes two minutes to be initiated.<br />
- During the two minutes of initiate mode, no activities are allowed to disrupt it.<br />
Installation Position:<br />
- The most sensitive position is the frontal area of the detector.<br />
- Avoid direct sunlight.<br />
- Avoid high temperature, air conditioning and strong wind if possible.<br />
- Avoid putting unnecessary moving objects <strong>with</strong>in the area.<br />
- It should be installed on a solid wall or roof that there is no vibration.