Cinema Referance Manual - Audio Design Associates
Cinema Referance Manual - Audio Design Associates
Cinema Referance Manual - Audio Design Associates
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Custom Setup - Turn On Volume<br />
The <strong>Cinema</strong> Reference’s “Out<br />
Of The Box” Setup has the<br />
<strong>Cinema</strong> Reference always<br />
turning on to VOLUME<br />
PRESET #1. Unless you have<br />
already locked in a new<br />
volume preset under <strong>Audio</strong><br />
Setup, this level will be -25.0<br />
dB.<br />
You can opt to alter the Turn<br />
On Volume to either VOLUME<br />
PRESET #2 or the LAST USED<br />
volume level. The steps<br />
described in the paragraph to<br />
the right detail how to change<br />
the <strong>Cinema</strong> Reference’s Turn<br />
On Volume.<br />
Note<br />
ADA strongly recommends<br />
using a Turn On Volume<br />
Preset whose level is not too<br />
high. Since the last volume<br />
used might be ear shattering,<br />
having the <strong>Cinema</strong> Reference<br />
turn on to a preset volume<br />
level removes the chance of<br />
engaging a system that is<br />
ready to sand-blast a room.<br />
This is providing that the<br />
Volume Preset you select is<br />
also of moderate level.<br />
The <strong>Cinema</strong> Reference has the ability to recall one of three volume<br />
levels when it is turned on. The Out Of The Box Setup has the<br />
<strong>Cinema</strong> Reference always turning onto VOL PRESET 1 which is<br />
factory set for all channels and all inputs at -25.0 dB. This level is<br />
typically a low or moderate volume level. If you have already completed<br />
the section on “<strong>Audio</strong> Setup”, then you may have already<br />
locked in a new audio preset on VOL PRESET 1.<br />
Factory Default Note: The <strong>Cinema</strong> Reference has been<br />
preprogrammed in the factory such that both VOL PRESET 1 and<br />
VOL PRESET 2 have the same preset level of all channels on all<br />
inputs set to -25.0 dB. If you wish to instantly recall the factory<br />
settings, simply proceed to recall VOL PRESET 2 by turning the<br />
CHANNEL knob until the display reads VOL RECALL 2 and then<br />
press the CHANNEL knob. If you wish to reset VOL PRESET 1 to<br />
the factory default as to begin again, once you have recalled VOL<br />
PRESET 2, simply turn the CHANNEL knob until the display reads<br />
VOL RECALL 1 and then press and hold the CHANNEL knob until<br />
the display reads VOL STORED 1.<br />
If you want the <strong>Cinema</strong> Reference to come on to a volume level<br />
other than VOL PRESET 1, you can alter it to come on to either VOL<br />
PRESET 2 or LAST USED.<br />
To alter the <strong>Cinema</strong> Reference’s Turn On Volume:<br />
1 Turn the MODE knob clockwise until the display reads SETUP<br />
MODE and then press the MODE knob.<br />
2 Turn the MODE knob clockwise to until the display reads<br />
TURNON VOL press the MODE knob. The top line of the<br />
display will read the current turn on volume setting.<br />
3 Turn the MODE knob until the display reads the desired turn<br />
on volume. Then press the MODE knob to lock in that<br />
turn on volume.<br />
Page 43