MT350 Clutch Replacement - Peak Riders
MT350 Clutch Replacement - Peak Riders
MT350 Clutch Replacement - Peak Riders
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>MT350</strong> <strong>Clutch</strong> <strong>Replacement</strong><br />
9. Remove the bolt circled above using a 6mm<br />
Allen Key . Locate the V in the fly wheel through<br />
the hole using a torch and screw in the crank<br />
locking bolt (the crank locking bolt is a M8 bolt<br />
with the end of the thread is tapered.)<br />
10. Mark the rotation of the Timing belt if you not<br />
replacing it.<br />
12. Remove the Timing Belt Tension bearing.<br />
11. Check the markings on the Pulleys and ensure<br />
they are all visible and Marked. Loosen the<br />
bolts marked with arrows.<br />
13. Remove the Timing Belt Runner Bearing.<br />
14. Remove the Bolt and washers on the top<br />
pulley, Remove the Belt then remove the pulley<br />
using the pulley removal tool.<br />
15. Remove the lower pulley nut and remove the<br />
pulley using the special removal tool.<br />
File Location file: http://www.peakriders.org/files/mt350/tutorial/mt350clutch.pdf<br />
Joth Hill 14-Apr-2012 Rev DRAFT Page 6 of 12