ACS5000-E/W Installation Manual - Brivo Systems

Page 14
Installation Manual
ACS5000-G Antenna Assembly & Mounting Procedures
Assemble and mount the antenna.
1. Attach the large connector of the internal antenna cable to the top of the Main Control Panel
chassis by sliding it up through the hole in the top of the chassis. Secure the connector with the
included nut.
2. Attach the small connector of the internal antenna cable to the modem mounted on the Main
Board. Do this by gently plugging the cable in at the lower left corner of the modem.
Figure 1.
ACS5000-G Antenna Assembly
WARNING: Cable Connectors
THE CONNECTORS ON THE INTERNAL ANTENNA CABLE ARE VERY FRAGILE.
Be very careful when plugging the connector into the modem. Do not press too hard
or you may break the connector off the cable.
3. If you believe the signal strength to the modem will be sufficient, screw the antenna into the
large connector that you have just attached to the top of the chassis.
4. If the signal strength to the modem is NOT likely to be sufficient, mount the antenna to an
external location.
a) Choose a desirable external mounting location for your antenna mounting bracket.
b)
connector through the bottom of the mounting bracket hole and secure it to the
mounting plate with the nut and washer.
c) Pick up the antenna and screw the bottom portion of it onto the top of the female
d)
bottom of the antenna making contact with the base. Your antenna is now assembled.
antenna connection at the top right side of the Brivo ACS panel.
© 2013 Brivo Systems, LLC. All rights reserved. 7/1/2013