ACS5000-E/W Installation Manual - Brivo Systems

More documents

Recommendations

Info

Page 20 Installation Manual Wire the AC transformer to the power supply WARNING: Transform Connection DO NOT CONNECT THE TRANSFORMER TO A SWITCHED OUTLET OR OTHERWISE CONTROLLED AC OUTLET. DO NOT CONNECT THE TRANSFORMER TO THE 120 VAC OUTLET UNTIL ALL WIRING IS COMPLETED. © 2013 Brivo Systems, LLC. All rights reserved. 7/1/2013
ACS5000 Page 21 1. Use 18 AWG wire (minimum grade) to connect the screw terminals on the transformer to the 16.5 VAC POWER INPUT terminal block on the power supply board, using terminals AC1 and AC2. Figure 7. Connect AC Transformer to Power Supply Attach Ferrite Bead (ACS5000-G Only) 1. Install the snap-on ferrite bead (L4) by snapping it onto the wires that run from the transformer to the power supply. a) Install the bead close to the 16.5 VAC transformer. b) Run the individual wires of the 18 AWG wire through the snap-on bead so that there are no turns in the wires. Figure 8. Attach Ferrite Bead © 2013 Brivo Systems, LLC. All rights reserved. 7/1/2013
Page 1 and 2: ACS5000 WebService Installation Man
Page 3 and 4: ACS5000 Page 3 © 2013 Brivo System
Page 9 and 10: ACS5000 Page 9 3. Make sure the acc
Page 11 and 12: ACS5000 Page 11 a) In addition to t
Page 13 and 14: ACS5000 Page 13 WARNING: Fail Secur
Page 15 and 16: ACS5000 Page 15 NOTE: To maximize s
Page 17 and 18: ACS5000 Page 17 a) Install the tamp
Page 19: ACS5000 Page 19 NOTE: If a chassis
Page 23 and 24: ACS5000 Page 23 c) For ACS5000-G co
Page 25 and 26: ACS5000 Page 25 Figure 13. Connect
Page 27 and 28: ACS5000 Page 27 Figure 15. CAN NODE
Page 29 and 30: ACS5000 Page 29 Figure 18. Wire Doo
Page 31 and 32: ACS5000 Page 31 7. Install MOV
Page 33 and 34: ACS5000 Page 33 Figure 20. EOL Resi
Page 35: ACS5000 Page 35 © 2013 Brivo Syste

ACS5000-E/W Installation Manual - Brivo Systems

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?