Service Manual - Haldex

3. Release the parking brake.
Initial and Final Procedures
If the disc brake is equipped with a parking brake function, ensure that
the brake system is depressurised, that the spring brake chamber is fully
disengaged and mechanically secured in the released position.
See the vehicle manufacturer’s instructions.
3.2.2 Removing the wheel
ModulT_055
Figure 6. Mechanically secure in the released position
Take all necessary safety precautions before wheel removal!
The vehicle manufacturer´s safety precautions shall also be followed!
1. Check the free rolling resistance, if the
resistance is higher than expected, tap the
tyre to remove any normal rest tension. If the
wheel still does not rotate freely then consult
chapter ”8. Fault Finding” to assist further.
2. Remove the wheel nuts followed by the
wheel, see figure 7.
ModulT_005
Figure 7. Remove the wheel
11