Family Dollar - Master-Bilt
Family Dollar - Master-Bilt
Family Dollar - Master-Bilt
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
INTRODUCTION<br />
Thank you for purchasing a <strong>Master</strong>-<strong>Bilt</strong> cabinet. This manual contains important instructions for installing, using,<br />
and servicing a <strong>Master</strong>-<strong>Bilt</strong> BLG/TLG case. A parts list is included with this manual. Read all these documents<br />
carefully before installing or servicing your equipment.<br />
STORE CONDITIONS<br />
The <strong>Master</strong>-<strong>Bilt</strong> BLG/TLG cases are designed to operate in the controlled environment of an air-conditioned store.<br />
The store temperature should be at or below 75°F and a relative humidity of 55% or less. At higher temperature or<br />
humidity conditions, the performance of these cases may be affected and the capacity diminished.<br />
The <strong>Master</strong>-<strong>Bilt</strong> BLG/TLG should not be positioned where it is directly exposed to rays of sun or near a direct source<br />
of radiant heat or airflow. This will adversely affect the case and will result in poor performance.<br />
If this case is to be located against a wall, there should be at least 6” space between the wall and the back of the<br />
case. This space will allow for the circulation of air behind the case, which will prevent condensation on the exterior<br />
surfaces.<br />
NOTICE<br />
Read this manual before installing your cabinet. Keep the manual and refer to it before<br />
doing any service on the equipment. Failure to do so could result in personal injury or damage to the<br />
cabinet.<br />
DANGER<br />
Improper or faulty hook-up of electrical components on the refrigeration units can result in severe injury or<br />
death.<br />
All electrical wiring hook-ups must be done in accordance with all applicable local, regional or national<br />
standards.<br />
NOTICE<br />
Installation and service of the refrigeration and electrical components of the cabinet must be performed by<br />
a refrigeration mechanic and/or a licensed electrician.<br />
The portions of this manual covering refrigeration and electrical components contain technical instructions intended<br />
only for persons qualified to perform refrigeration and electrical work.<br />
This manual cannot cover every installation, use or service situation. If you need additional information, call or write<br />
us:<br />
Customer Service Department<br />
<strong>Master</strong>-<strong>Bilt</strong> Products<br />
Highway 15 North<br />
New Albany, MS 38652<br />
Phone (800) 684-8988<br />
Fax (800) 684-8988<br />
4