43-06937 INSERT-EPIC 430 OEM INTEGRATION MANUAL - TransAct

Control Codes
Function Redefine User Store Termination Character
ASCII
[ESC] [EM] T
Hexadecimal 1BH 19H 54H
Decimal
IPCL
&%UT
EPOS
None
Description This command allows the terminator used to signal the end of the
name field in User Store commands to be modified. The value of is used
(in addition to the ) for the terminator. The value of n may be from 0 to
255.
The default value for the second terminator is &. If this command redefines
the terminator to something other than &, the & will no longer function.
Example If &%UT% were sent to the printer, the user store command to run
macro “Demo” would be &%URDemo%.
Legacy User Macros
The following commands are provided for legacy support. They are not
intended for new applications.
[ESC] g
Process user macro
ASCII [ESC] g
Hexadecimal 1BH 67H 00H
Decimal
IPCL
&%GP
EPOS [ESC] g
Description The [ESC] g command prints the user-store data buffer.
[ESC] g
Start macro record
ASCII [ESC] g
Hexadecimal 1BH 67H 01H
Decimal
IPCL
&%GS
EPOS ESC] g
Description The [ESC] g command clears the user-store data buffer and
begins recording data. The next 2000 bytes (including characters and
commands) are recorded.
43-06938 Rev L Page 125