Ithaca 610 Programmer's Guide - TransAct

Specifications and Requirements
Ithaca ® 610 Programmer’s Guide
General Specifications
Printing Specifications
Printing method:
Vertical/Horizontal dot pitch:
Resolution:
Line feed pitch:
Print zone (maximum)
Print speed:
Number of print elements:
Thermal sensitive line dot system
0.125 mm.
8 dots per mm (203 DPI)
3.2 mm. (.125 inches)
80 mm (3.15 inch)
8 inches per second
640 dots in-line
Character Pitch
The Ithaca ® 610 has 3 basic resident fonts, as well as downloadable fonts. The smallest
internal font is a 10 x 24 font and is typically printed in pitches from 16 to 20 characters
per inch (CPI). The next larger font is 13 x 24, and is typically printed in pitches from 14
to 16 CPI. The largest font is 15 x 24 and is typically printed in pitches from 10 to 14 CPI.
The printer always prints at 203 dots per inch (dpi). Adding or subtracting space between
characters achieves different character pitches. As each dot has a fixed size and
position, only specific pitches are possible. The following table defines the fonts and
pitches possible with each.
Character Cell (H x W)
10 x 24 Font
(W x H)
13 x 24 Font
(W x H)
15 x 24 Font
(W x H)
Horizontal Width
10 Dots
0.0493 inches
13 Dots
0.0640 inches
15 Dots
0.0739 inches
Vertical Height
24 Dots
0.118 Inches
24 Dots
0.118 Inches
24 Dots
0.118 Inches
Character spacing in Characters per Inch (CPI)
Pitch at native cell size 20.30 15.62 13.5
5 dot Removed 40.60 25.38 20.30
4 dot Removed 33.83 22.56 18.45
3 dot Removed 29.00 20.30 16.92
2 dot Removed 25.38 18.45 15.62
1 dot Removed 22.56 16.92 14.50
0 dot added 20.30 15.62 13.53
1 dot added 18.45 14.50 12.69
2 dots added 16.92 13.53 11.94
3 dots added 15.62 12.69 11.28
4 dots added 14.50 11.94 10.68
5 dots added 13.53 11.28 10.15
6 dots added 12.69 10.68 9.67
NOTE: Shaded Pitches are not recommended.
Table 1 Possible Character Pitches
Requested CPI
Character
Width Resulting CPI Requested CPI
Character
Width
Resulting CPI
1 203 1.00 16 12 16.92
Page 14 Rev D 28-05897