Std Frame_Install.pdf - Aztec

Step 13:
Lift up one side of the tent off the ground and slide two of the
leg pipes over the corner fitting and pin into place. Tent Jacks
(optional accessory) are shown to aid in the lifting of the frame.
Either using tent jacks, man power, or another lifting device the
frame needs to be supported at every leg when lifting to prevent
undue stress on frame members.
Step 14:
Lift up the other side of the tent and install and pin the leg
pipes on the other two corner fittings and middle legs.
Step 15:
Anchor the tent with the included stakes and ropes. The ropes
should be tied around each of the perimeter fittings with an
overhand slip knot. The stakes should be driven approximately
six (6) feet away from the bottom of the leg. To achieve proper
rope tension, drive each stake approximately 24” into the
ground with a sledge hammer. Tie the rope to the stake with a
clove hitch and continue driving the stake into the ground until
the rope is tight.
www.aztectents.com