Alesis MidiVerb 4 Reference Manual - They Remained Silent
Alesis MidiVerb 4 Reference Manual - They Remained Silent
Alesis MidiVerb 4 Reference Manual - They Remained Silent
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 4 – Editing Programs<br />
Editing Effect Parameters<br />
Editing Programs is only possible while in Program mode. This means that the<br />
[PROG] button must be lit. If the [PROG] button is not lit, press it now. From<br />
Program mode, you can edit the currently selected Program by pressing either<br />
[EDIT/PAGE] or any of the [A], [B], [C] or [D] buttons. Upon entering Edit mode, the<br />
display will change to show you up to four parameters associated with the selected<br />
Program.<br />
3<br />
4<br />
1<br />
01<br />
PAGE 1 2 3<br />
PRESET<br />
Decay LPF PDly PMix<br />
395 § 2@8 ∂ 150© ¢ 000å¡<br />
A B EDITED C D<br />
L<br />
R<br />
2<br />
5<br />
➀ Page Numbers . Depending on the Configuration, there will be<br />
up to four pages available in Edit mode. In this example, only three<br />
pages are available.<br />
➁ Selected Page . The currently selected page will be indicated by<br />
a box around its number. In this example, page 1 is currently<br />
selected. Each time you press the [EDIT/PAGE] button, the display will<br />
advance to the next page.<br />
➂ Parameter Name Strip . Each page in Edit mode contains up to<br />
four parameters. whose names will appear at the top of the display,<br />
above their value settings.<br />
➃ Parameter Values and Bar Graphs . Each parameter in the<br />
selected page is shown with both a numerical value and a bargraph.<br />
When a parameter is selected for editing, its value will flash in the<br />
display. As you adjust a parameter, both its numerical value and<br />
bargraph will change in relation to the [VALUE] knob’s position. The<br />
type of units a parameter uses will be shown as well (dB, kHz, etc.).<br />
➄ A, B, C, D and EDITED Indicators . Each parameter in the selected page is<br />
designated by a letter (A, B, C or D), which indicates which button ([A], [B], [C]<br />
or [D]) should be pressed to select the desired parameter for editing. Once a<br />
parameter has been edited, the word “EDITED” will appear below it.<br />
40 <strong>MidiVerb</strong> 4 <strong>Reference</strong> <strong>Manual</strong>