Medallion-Lok Installation Manual - McElroy Metal

MEDALLION-LOK
HIGH SIDE TIE-IN - SIDEWALL PARAPET ABOVE ROOFLINE
Sealant (Not by McElroy)
Counter Flashing
(Not by McElroy)
Parapet Wall
Fastener (Not
by McElroy)
43D Pop Rivet
at 0’ - 6” O.C.
Tie-In Trim
Zee Closure (Field Cut)
w/1” Roll Tape Sealant
Top and Bottom
Medallion-Lok Panel
6” Max.
Butyl Tube Sealant
Medallion-Lok Clip
Min. #30 Felt Paper
(Recommended)
Pancake Head Fastener
#10 - 12 x 1” Type A
Substructure
Hex Head Fastener
#9 - 15 x 1” Type A Woodgrip
2 Required per Panel
(Must Penetrate Tape Sealant)
Counter Flashing
(Not by McElroy)
Sealant (Not by McElroy)
Parapet Wall
Tie-In Trim
Medallion-Lok
Panel
Zee Closure
w/1” Roll
Tape Sealant
(Top and
Bottom)
Min. #30 Felt Paper (Recommended)
Substructure
NOTES:
1. After panels are installed, place a continuous run of 1” roll tape sealant approximately 6” from
edge of wall subtructure.
2. Field cut zee closure and install over tape sealant and attach with two (2) #9 - 15 x 1”
fasteners through closure, sealant, panel and into substructure. Locate as shown.
3. Apply tube sealant to zee closure and panel ribs.
4. Apply a continuous run of 1” roll tape sealant over zee closure and fasten trim to closure with
43D pop rivets on 6" centers. Use tube sealant at closure.
5. Fasteners for attachment to parapet wall is not by McElroy Metal.
6. Counter flashing and sealant to parapet wall are not by McElroy Metal.
19
▲