Haas lifting instruction_lathe and mill
Haas lifting instruction_lathe and mill
Haas lifting instruction_lathe and mill
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Haas</strong> Technical Publications<br />
Lifting Instructions<br />
EC-300/MDC-500 Lifting Hardware Details<br />
1. Before <strong>lifting</strong> the machine, remove the hole<br />
plugs <strong>and</strong> install four 1"-8 TPI forged steel<br />
shoulder eyebolts, 1" steel washers <strong>and</strong><br />
spacers.<br />
EC-300 Only<br />
Top Panels<br />
EC-300 only - Remove the two top panels.<br />
C<br />
42” (107 cm)<br />
16” (41 cm)<br />
2. Once the machine is in position, remove the<br />
eyebolts from the <strong>lifting</strong> holes <strong>and</strong> replace with<br />
bolts <strong>and</strong> washers<br />
3. After installation, re-install the chip screen with<br />
bolts <strong>and</strong> washers.<br />
This dimension is<br />
critical to prevent the<br />
lift chain from<br />
contacting the<br />
spindle head cover.<br />
*<br />
*<br />
25”<br />
(64 cm)<br />
MDC<br />
Chip Screen<br />
DUAL PA LET<br />
INLINE<br />
SPINDLE<br />
*<br />
*<br />
4X Lifting Eyebolt<br />
Spacer<br />
4X Forged Steel Shoulder Eyebolt<br />
1”- 8 TPI <strong>and</strong> 1” Steel Washer<br />
Min 9000 lb Working Load<br />
Limit (WLL) at Vertical Pull (08)<br />
ES0246 Rev AN Jan 2013 Page 14 of 31