Haas lifting instruction_lathe and mill

More documents

Recommendations

Info

Haas Technical Publications Lifting Instructions EC-300/MDC-500 Lifting Hardware Details 1. Before lifting the machine, remove the hole plugs and install four 1"-8 TPI forged steel shoulder eyebolts, 1" steel washers and spacers. EC-300 Only Top Panels EC-300 only - Remove the two top panels. C 42” (107 cm) 16” (41 cm) 2. Once the machine is in position, remove the eyebolts from the lifting holes and replace with bolts and washers 3. After installation, re-install the chip screen with bolts and washers. This dimension is critical to prevent the lift chain from contacting the spindle head cover. * * 25” (64 cm) MDC Chip Screen DUAL PA LET INLINE SPINDLE * * 4X Lifting Eyebolt Spacer 4X Forged Steel Shoulder Eyebolt 1”- 8 TPI and 1” Steel Washer Min 9000 lb Working Load Limit (WLL) at Vertical Pull (08) ES0246 Rev AN Jan 2013 Page 14 of 31
Haas Technical Publications Lifting Instructions EC-400/500 Lift Placard Refer to the lifting placard for EC-400/500. Attach chains to the lifting points as shown. Ensure that the chains do not contact the sheet metal enclosure or electrical cables. ES0246 Rev AN Jan 2013 Page 15 of 31
Page 1 and 2: Haas Technical Publications ES0246
Page 3 and 4: Haas Technical Publications Lifting
Page 13: Haas Technical Publications Lifting
Page 31: Haas Technical Publications Lifting

Haas lifting instruction_lathe and mill

Create successful ePaper yourself

Delete template?

Save as template?