INTECONT Satus Commissioning and Set-Up Assistant - Schenck ...

More documents

Recommendations

Info

3.2 Powering-Up and Awaiting System Start Relay Output Connections Figure 7: Relay Output Connections Overall BEMP System Connections Figure 8: Overall BEMP System Connections 3.2 Powering-Up and Awaiting System Start Once the Mechanical and Electrical Installation is complete, power-up the system. 8 BV-H5123GB / 0852 INTECONT Satus Commissioning and Set-Up SCHENCK AccuRate
3.3 Setting Parameters for Blocks A,B,C 3.3 Setting Parameters for Blocks A,B,C Customer parameters have been pre-set at SCHENCK AccuRate. Check the program against your parameter data sheet. The 14 parameters listed below may require adjustment. Figure 9: Parameter List Follow the steps below to set Parameter C 02: 1. With the BEMP turned OFF, use a piece of brown masking tape and pick a spot on the belt where it is easily accessible and place the piece of tape on it. 2. Turn the BEMP ON. The belt must be running for the next step. 3. Measure and record the time (in seconds) required for one belt circuit as accurately as possible and enter this time for parameter C 02. NOTE: Please note that the belt drive is not controlled by the set-up program and the set-up program will be interrupted with a corresponding message if one of the preconditions are not met. 4. To begin entering data, press the Function key. 5. Using the or keys, select Programming. 6. Press Enter. 7. Using the or keys, select Enter Parameter. 8. Press Enter. 9. Confirm the selection by pressing Enter. 10. The system will prompt for a password. Use the default password 07734. Use thekeys to move the cursor to the digit that is to be changed. Use the or keys to increase or decrease that digit. INTECONT Satus Commissioning and Set-Up BV-H5123GB / 0852 9 SCHENCK AccuRate
Page 1 and 2: BV-H5123GB INTECONT Satus Commissio
Page 3 and 4: Table of Contents 1 Introduction .
Page 5 and 6: 1.3 Safety 1 Introduction 1.1 What
Page 7 and 8: 2.1 INTECONT Satus Operator Interfa
Page 9 and 10: 3 INTECONT Satus Commissioning This
Page 11: 3.1 Verify Mechanical and Electrica
Page 15 and 16: 3.4 Executive Set-Up Programs 3.4 E
Page 17 and 18: 3.4 Executive Set-Up Programs NOTE:
Page 19: 3.5 Setting Limit Values 3.5 Settin

INTECONT Satus Commissioning and Set-Up Assistant - Schenck ...

Create successful ePaper yourself

Delete template?

Save as template?