OPERATOR'S AND PARTS MANUAL - Walker Mowers

ASSEMBLY
LAWN DETHATCHING WHEEL KIT - WAL0001 (OPTION)
Installation
(Figure 11)
1. Remove the parking stands (item 9) from
the supports (item 1) on each side of the
broom. Remove the chain guard (item 11)
by unscrewing the two bolts (item 10) to
gain access to the inferior hole on the left
side of the broom.
2. Remove the lower 5/16" x 1/2" flange bolt
(item 7) from the support. Loosen the upper
5/16" x 1/2" flange bolt and then turn
support counter clockwise to remove it.
3. Attach the left wheel assembly on the
broom left side as shown on figure with two
5/16"NC x 1" serrated flange bolts (item 5),
5/16"NC serrated flange nuts (item 6) and a
5/16"NC x 1/2" serrated flange bolt (item 7).
4. Attach the right wheel assembly on the
broom right side with the two existing bolts
(item 8), and as for the left side, with a
5/16"NC x 1/2" serrated flange bolt (item 7).
5. Insert the assembled wheel
adjustments (item 3) into the
left and right wheel supports
(item 2) and secure in place to
the maximum height with a
round wire lock pin (item 4).
6. Reinstall the parking stands
(item 9) to the working
position in the wheel supports
as well as the chain guard
(item 11).
Figure 11
Adjustment
To adjust the height of the wheel -1/2" (13 mm)
at a time, from 3" (76 mm) minimum to 7" (178
mm) maximum - slide the inner tube upward or
downward, as needed, and insert the round
wire lock pin in the open hole.
We recommend adjusting the wheel height to
1" (25 mm) lower than the brush height to
make a first try on the grass. Then raise or
lower the wheels as required.
(76 mm) (178 mm)
OM 0182BR47-A 14