CLI Guide - TP-Link
CLI Guide - TP-Link
CLI Guide - TP-Link
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
no gvrp timer [ leaveall | join | leave ]<br />
Parameter<br />
leaveall | join | leave —— They are the three timers: leave All、join and leave.<br />
Once the LeaveAll Timer is set, the port with GVRP enabled can send a<br />
LeaveAll message after the timer times out, so that other GARP ports can<br />
re-register all the attribute information. After that, the LeaveAll timer will start to<br />
begin a new cycle. To guarantee the transmission of the Join messages, a<br />
GARP port sends each Join message two times. The Join Timer is used to<br />
define the interval between the two sending operations of each Join message.<br />
Once the Leave Timer is set, the GARP port receiving a Leave message will<br />
start its Leave timer, and unregister the attribute information if it does not receive<br />
a Join message again before the timer times out.<br />
value ——The value of the timer. The LeaveAll Timer ranges from 1000 to<br />
30000 centiseconds and the default value is 1000. The Join Timer ranges from<br />
20 to 1000 centiseconds and the default value is 20. The Leave Timer ranges<br />
from 60 to 3000 centiseconds and the default value is 60.<br />
Command Mode<br />
Interface Configuration Mode (interface gigabitEthernet / interface range<br />
gigabitEthernet)<br />
Example<br />
Set the GARP leaveall timer of port 6 to 2000 centiseconds and restore to the<br />
join timer of it to the default value:<br />
TL-SG3424(config)# interface gigabitEthernet 1/0/6<br />
TL-SG3424(config-if)# gvrp timer leaveall 2000<br />
TL-SG3424(config-if)# no gvrp timer join<br />
show gvrp global<br />
Description<br />
The show gvrp global command is used to display the global GVRP status.<br />
Syntax<br />
show gvrp global<br />
Command Mode<br />
Privileged EXEC Mode and Any Configuration Mode<br />
36