Tectite Push Fit Solutions - Pegler Yorkshire

Push-fit solutions
Installation instructions
10mm to 28mm sizes
Jointing
1. To make a perfect joint, the tube or pipe must be fully inserted
in the fitting until it meets the tube stop. To confirm that this
is the case, mark the socket depth on the tube or pipe using
the appropriate socket depth marker or a tape measure and a
marker/pencil. For the socket depth of each size of fitting,
see tables on page 58.
1
NOTE: Tectite Sprint and Tectite Advance fittings must not be
used with the male ended fittings from other Tectite ranges
(except T526S). Other third party male ended products should
not be used with any Tectite fittings.
Do not use Tectite fittings on gas services.
Tectite Classic fittings do not provide electrical continuity, other
Tectite fittings only provide electrical continuity when installed
with metal tube.
2. Inspect the fitting ensuring that the grab rings/‘O’-rings have
not been contaminated with grit or debits. Insert the tube/pipe
into the mouth of the fitting to rest against the grab ring.
2
3. Push the tube firmly with a slight twisting action until it
reaches the tube stop with a positive “click”.
4. Ensure the depth insertion mark corresponds with the mouth of
the fitting and then pull firmly on the tube to ensure the fitting
is secure.
NOTE: We recommend all systems are thoroughly pressure
tested to 1.5 times working pressure before the hand-over to
the customer.
4
60 1 Range overview 2 Product details 3 Technical data 4 Installation instructions