NEWS 2005 - Jan Havelka

KSCM Face Mills
Cutter Cartridge Assembly
NEW
Tool configuration cartridge for defined surface, 75°
1. Insert cartridges
into the body.
2. Screw in the
clamping screws
(RH), and tighten
to 10 Nm.
3. Screw in the
adjusting screws
(RH), and
tighten to 3 Nm.
4. Determine which
cartridge is in the
highest axial
position.
5. By turning the
adjusting screws
to the right, adjust
the remaining
cartridges for
even running.
Max. permitted
run-out error
3 µm.
-KSCMCA75PT
INSERTS
FACE MILLING
Tool configuration universal cartridge + roughing cartridge (ratio approx. 1:1), 75°
1. Insert universal
cartridges into
every second
seating in the
body.
2. Screw in the
clamping screws
(RH), and tighten
to 10 Nm.
3. Screw in the
adjusting screws
(RH), and tighten
to 3 Nm.
4. Determine
which cartridge
is in the highest
axial position.
5. By turning the
adjusting screws
to the right,
adjust the
remaining
cartridges for
even running.
Max. permitted
run-out error
3 µm.
6. Insert roughing
cartridges into
the remaining
seatings.
7. Screw in the
clamping
screws (RH),
and tighten to
10 Nm.
8. Screw in the
adjusting
screws (RH),
and tighten to
3 Nm.
MILLING
END MILLING
Use cartridges KSCMCA75UN and KSCMCA75HR.
SLOTTING / HELICAL
Note:
The process must be repeated when the cartridges are changed.
To dismantle, remove the adjusting element (Part 3), clamping screw
(Part 2), and cartridge (Part 1).
DIE & MOLD
To place an order, contact your Kennametal representative or visit www.kennametal.com.
B43