VideoSMS/Client Application Programming Interface ... - MCTel

VIDEOSMS SMS Management Functions (outside Premium session)SMS_WAPPushThe following optional data could be specified if needed:• msg_class: spécify the message class:5 0: class 0: flash mode: immediate display of the message on themobile screen without user intervention, but no storage of themessage in the received messages list.5 1: class 1: normal mode (default): the SMS is received and storedin the list of received message. The user must open the receivedmessage list to read the message.5 2: classe 2: stored on SIM card.5 3: classe 3: equipment specific.• srcPort: sending port message, only used for binary NBS messages.• destPort: recipient port message, only used for binary NBS messages.• alternate_number: alternate SMS or fax number that could be usedfor message transmission should the primary number be unreacheableand the bit 4 of sms_options be set.• caller_number: sender identifier. In some networks it is possible toset the sender identifier in numeric (phone number) or alphanumericformat. On most networks, the sender identifier could not be setand the SMS is sent using the gateway shortid allocated to the SMSGateway by the network operator.• sender_address: email address of the sender. When bits 20 and/or 21of sms_options are set, a transmission report or error notification couldbe sent by email to this address after either successful transmission orerror.• msg_options: bitarray storing SMS options:5 bit 1 set: deferred SMS to send at the date/time specified indeferredDate.5 bit 2 set: SMS to send in priority mode.5 bit 3 set: SMS expiration date specified in expirationDate.5 bit 4: alternate SMS number specified in alternate_number to usewhen the recipient number could not be reached.5 bit 5: SMS acknowledgement request for errors or successfultransmission.5 bit 16 set: allows routing of incoming SMS replies to the originator.5 bit 17 set: the application_name field is used to store applicationspecificdata (maximum length = 50 bytes).5 bit 18 set: the private_reference field encodes the applicationprivate reference that will be returned in the message transmissionacknowledgements.5 bit 20 set: request that an error notification be transmitted byemail to the sender in case of transmission error.5 bit 21 set: request for a transmission acknowledgement to be sendby email after Wap Push successful transmission.5–8