Turbo Select Manual - Grill-Repair.com

Ignitor Battery Installation - See Figure 61. Unscrew the Ignitor Cap located on the Grill ControlPanel and remove the Contact and Spring from theIgnitor Slot.2. Place the manufacturer supplied AA battery into theIgnitor Slot. Be sure to place the positive pole facingtoward you.3. Place the Spring over the AA battery, then placethe Contact on top of the Spring. Screw the IgnitorCap back onto the grill Control Panel.5. If no "clicking" sound is heard check thefollowing common causes.If you needassistance call Barbeques Galore InfoCenter at 1-800-474-5587.• Ignitor AA battery not installed properly.• Ignitor wires may be loose. Remove the AAbattery, inspect the Ignitor Junction Boxfound behind the Control Panel, and connectany loose wires.Electrode CheckFigure 6Requires and assistant:Before placing the cooking components into yourgrill, insure that the Spark Electrode Tip is properlypositioned within each Gas Collector Box (stainlesssteel mechanism found at the front between eachset of Burners.) The easiest way to insure this isto perform this Electrode Check:CONTRACTSPRINGIGNITOR CAPIGNITOR SOLT1. Be sure all Control Knobs are set to "OFF"and open the Grill Lid.2. Have an assistant stand behind to the right ofthe grill and look down at each Gas CollectorBox. NEVER put your face inside Grill Head.3. Push the ignition Cap. You should hear aclicking sound and your assistant should seea small blue spark within each Gas Collector Box.If a spark is present the Electrode Tips areproperly positioned.4. If no spark is seen the Spark Gap shown inFigure 7 needs to be adjusted as follows:• Using an adjustable wrench, loosen the insideNut just until the Gas Collector Box can bemaneuvered and turned upward.POSITIVE POLEAA BATTERYFigure 7 - Side View Gas Collector BoxSPARK GAP• The gap between the Spark Electrode Tip andSpark receiver should be approximately 3/16".• If the gap is wider than 3/16" use a pair of longnose pliers and gently squeeze the GasCollector Box until the gap is correct.• Return the Gas Collector Box to its originalhorizontal position, secure the inside Nut and trythe Electrode Check again.SPARKELECTRODE TIPINSIDENUTBarbeques Galore Information: If you have questions about assembly or grill operation, or if there are damagedor missing parts when you unpack this unit from the shipping boxes, call us 8am - 4:30 pm PST, Mondaythrough Friday at: 1-800-474-5587 (1-800-GRILL-UP)13