Cooling/Casting - Spraying Systems Co.

Lubrication/Cooling/Strip Wash-OffVeeJet Flat Spray Nozzles ProvideMore Surface Contact for Efficientand Uniform CoolingWhen you need to remove heat during steel forming, our VeeJet spray nozzlesare called for. Providing a flat tapered-edge spray pattern, VeeJets efficiently anduniformly cool the entire width and length of the rolls using overlapping spray patterns.The greater surface contact of the sprays helps utilize available water andcontrols steel expansion and contraction and ultimately contour distortion.Our VeeJet nozzles offer the added advantage of being compact. This enables positioninga greater number of nozzles closer to the target to maximize heat removal,prevent scouring and extend roll life.Available in a wide variety of sizes, capacities, spray angles, materials and connectiontypes, VeeJet nozzles are often also used in cleaning and rinsing of pickledstrip after an acid bath.VeeJet Spray Nozzles – Efficient Heat Removal in Hot Strip andRolling Mill Applications; Effective Cleaning in Other AreasOur VeeJet flat spray nozzles produce a uniform distribution of small- to medium-size drops in a high-impactflat spray pattern with spray angles ranging from 15° to 110° at 40 psi (3 bar). Inlet connections range from1/8” to 1/2”, some with quick-connect spray tips. Most commonly used in roll cooling, VeeJet nozzles are alsoused in run-out tables, lubrication, strip wash and liquor flushing.H-VV H-VVL H-U1/8” to 1/4” NPT or BSPT (M)• H-VV VeeJet nozzles feature flowrates below 1 gpm at 40 psi (3.9l/min at 3 bar).• H-VV and H-VVL nozzles are availablewith spray angles of 15° to110° at 40 psi (3 bar).Integral strainer1/8” to 1/4” NPT or BSPT (M)• H-VVL VeeJet nozzles offer the sameflow rates as the H-VV but feature abuilt-in strainer.221/8” to 1/2” NPT or BSPT (M)• H-U VeeJet nozzles feature low flowrates of 1 gpm or greater at 40 psi(3.9 l/min at 3 bar).• H-U nozzles feature spray angles of15° to 110° at 40 psi (3 bar).