INSTRUCTION MANUAL - Vivitar

More documents

Recommendations

Info

Assembling Your Telescope1.Remove the tripod legs from the box andextend each of them to a suitable length fromtop to bottom, and then tighten the lockingknob (see fig. 1).-5-
Assembling Your Telescope (continued)2. Connect each leg and the mount base using longscrews and wing nuts (see fig. 2a), but not tighten.3. Stretch out the tripod legs so that you can put theaccessory dish on it, connecting them with short screwsand wing nuts (see fig. 3) . Tighten the wing nuts of thetripod legs.4. Connect the pitching shaft to the main tube using thepitching shaft screw (see fig. 2b) .5. Loosen the left and right blocks on the main tube, andthen connect the main tube to the main mount. Tightenthe right and left blocks (see fig. 2c) and tighten thepitching clamp handle screw (see fig. 2d ).-6-
Page 3 and 4: WHAT TO DO WHEN SERVICE IS NEEDEDST
Page 5: IntroductionThank you for purchasin

INSTRUCTION MANUAL - Vivitar

Create successful ePaper yourself

Delete template?

Save as template?