Amphenol Solutions Guide.pdf - Military Systems & Technology

5015 - AMPHENOL 97 SERIES MIL-DTL-5015ASSEMBLY INSTRUCTIONSREAD THESE INSTRUCTIONS PRIOR TO ASSEMBLY.STEP 1: Open both shell kit andinsert kit.STEP 2: Remove yellow tape frominsert, being careful not to allow frontand rear insulators to come apart.STEP 3: Insert insulator assemblyinto shell or barrel, aligning the keyand keyway until rear of the insertis positioned just below the retainingspring ring ridge.STEP 4: Insert the retainer spring ringinto the ridge by working one end infirst, then working around the ring untilit snaps into place.STEP 5: For barrels, add coupling nutto barrel and slide rear accessories onto cable.STEP 6: Solder wires ontoproper contacts.STEP 7: Thread endbell onto barrel/shell. Slide cable clamp down the cableand thread onto the endbell. Tightenendbell and cable clamp using endbellaccessory tools aSee page 114.STEP 8: Tighten cable clamp screwsappropriately for the specific wire/cablein use.20For assistance in North America: +1 800.642.8750 for Pricing/Delivery or +1 800.523.0727 Tech Support • www.peigenesis.com • sales@peigenesis.com