Completing the Industrial Wastewater Permit Application - TCEQ e ...

If the site of your business is part of a larger business site, an RN may already be assigned for thelarger site. Use the RN assigned for the larger site. Search TCEQ’s Central Registry to see if thelarger site may already be registered as a regulated site at:http://www15.tceq.texas.gov/crpub/index.cfm?fuseaction=regent.RNSearchIf the site is found, provide the assigned RN and provide the information for the site to beauthorized through this application below. The site information for this authorization may varyfrom the larger site information.An example is a chemical plant where a unit is owned or operated by a separate corporation thatis accessible by the same physical address of your unit or facility. Other examples includeindustrial parks identified by one common address but different corporations have control ofdefined areas within the site. In both cases, an RN would be assigned for the physical addresslocation and the permitted sites would be identified separately under the same RN.a. State/TPDES Permit No.Provide the TCEQ Permit No. and the EPA Identification No. if the facility has an existingpermit. For new facilities, these spaces should be marked N/A.b. Name of the Project or SiteProvide the name of the site as known by the public in the area where the site is located. Thename you provide on this application will be used in the TCEQ Central Registry as the RegulatedEntity. An RN will be assigned by Central Registry if this site is not currently regulated by TCEQ.c. Edwards Aquifer ProximityIndicate whether the facility is located in Bexar, Comal, Hays, Kinney, Medina, Travis, Uvalde,or Williamson County. The Edwards Aquifer is located under the boundaries of these counties. Ifthe facility is or will be located in one of these counties, 30 TAC §215, Edwards Aquifer Rules,may be applicable and the applicant may be required to provide additional information.d. Site/Project (Regulated Entity) Physical AddressEnter the complete address of where the site is located. This address must be validated throughUS Postal Service. If the physical address is not recognized as a USPS delivery address, you mayneed to validate the address with your local police (911 service) or through an online map site.Please confirm this to be a complete and valid address. Please do not use a rural route or postoffice box for a site location.If a site does not have an address that includes a street (or house) number and street name,enter NO ADDRESS for the street name. For all permits regardless of having a street address ornot, provide a complete written location access description. For example: “The site is located 2miles west from the intersection of Highway 290 IH35, located on the southwest corner of theHighway 290 South bound lane.” Do not provide directions to the facility. The locationdescription must use easily identifiable landmarks found on the USGS map submitted with theapplication. The description must include the direction and distance in feet or miles from roadintersections. If the existing permit includes an accurate description, indicate so bychecking yes on the application form. If, however, the application is for a new facility orthe description is inaccurate, provide an accurate description. Two examples of acceptablelocation descriptions are: (1) The facility is located 2,600 feet southwest of the intersection ofState Highway 20 and Farm-to-Market Road 1200; (2) The facility is located approximately 1.2miles east of the intersection of Farm-to-Market Road 345 and County Road 10. NOTE: a newlocation requires a new (separate) permit - permits are site specific.10411_10055-inst (7/14/2014) Instructions for Completing the Industrial Wastewater Application Page 28 of 124