Completing the Industrial Wastewater Permit Application - TCEQ e ...

If ponds (i.e., holding ponds, evaporation ponds) are located on land not owned by theapplicant, there are two options: 1)the owner of the land can apply for the permit as a copermitteeor 2) the applicant must provide a copy of an executed deed recorded easement. Thedeed recorded easement must give the facility owner sufficient rights to the land for theoperation of the facility and must be recorded in the county where the facility is located.If the land is to be acquired by the facility owner, a copy of an executed option to purchaseagreement must be submitted. The option to purchase must give a legal description of the landto be purchased and identify when the option to purchase agreement expires. An option topurchase may only be submitted with a new permit application.m. Owner of the Sewage Sludge Disposal Site:Provide the name and mailing address of the owner of the sewage sludge disposal site. Theowner of the sewage sludge disposal site only needs to be provided if authorization for thedisposal of sewage sludge on property owned or under the direct control of the applicant is beingsought in the permit. If the owner of the land where the sewage sludge disposal site is located isnot the same as the applicant, a long-term lease agreement for at least the term of the permitmust be provided. If sludge is hauled by a registered transporter to a separate sitethat is permitted or registered by the TCEQ, such as a municipal solid wastelandfill or a registered land application site, ownership information does not needto be provided.8. DISCHARGE/DISPOSAL INFORMATIONThe following information provides specific location information used in describing the locationof the facility, the discharge route, the effluent disposal site, and other information relevant tothe facility.For every application (TPDES and TLAP), provide responses to Items a – c. If this application isfor a TPDES permit, also provide responses to the TPDES-related Items (d – i); or if thisapplication is for a TLAP permit, also provide responses to the TLAP-related Items (j – o).a. Indian LandIndicate whether the facility is located on, or the discharge route passes through, Indian Land bychecking “yes” or “no”.b. USGS Topographic MapFor Renewal, Major and Minor Amendment applications, provide an 8.5"×11",reproduced portion of the most current and original USGS Topographic map(s) that meets the1:24,000 scale.For New applications, provide an original, full size, 7.5-minute USGS Topographic QuadrangleMap(s). The original USGS quadrangle map(s) must be in color, have a scale, and have thelatitude and longitude on all four sides of the map. You can obtain an original, full size, 7.5-minute USGS Topographic Quadrangle map by calling the USGS at (888) 275-8747.For all USGS Map submittals, the maps must contain the applicable information below,clearly outlined and labeled on original and copy portion USGS Map• one mile in all directions from the facility. If more than one map is required to showone mile in all directions from the facility, provide each individual map. Do not splicetogether.10411_10055-inst (7/14/2014) Instructions for Completing the Industrial Wastewater Application Page 30 of 124