ADK Sensor Kit Shield - TinkerKit Mega Sensor Shield V.2 - Elfa

More documents

Recommendations

Info

_____________________________________________________________________________20 cm long wires for the TinkerKit with a 3 pin jumper on both sides50 cm long wires for the TinkerKit with a 3 pin jumper on both sides.100 cm long wires for the TinkerKit with a 3 pin jumper on both sides_____________________________________________________________________________Arduino ADK Rev3Code: A000069The Arduino ADK R3 is a microcontroller board based on theATmega2560 (datasheet). It has a USB host interface to connect withAndroid based phones.It is compatible with Android's Accessory Development Kit examples. Ithas 54 digital input/output pins (of which 14 can be used as PWMoutputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHzcrystal oscillator, a USB connection, a power jack, an ICSP header, anda reset button.The ADK is based on the Mega 2560. Plus it has an USB Host circuit thatenable this board to communicate with USB Devices, and give them
power supply.Additional features coming with the R3 version are:ATmega16U2 instead 8U2 as USB-to-Serial converter.1.0 pinout: added SDA and SCL pins for TWI communication placed near to the AREF pinand two other new pins placed near to the RESET pin, the IOREF that allow the shields toadapt to the voltage provided from the board and the second one is a not connected pin,that is reserved for future purposes.stronger RESET circuit.
Page 1 and 2: ADK Sensor KitCode: K000006The ADK
Page 3 and 4: Output: This module contains two co
Page 5 and 6: potentiometer, a signal amplifier,
Page 7 and 8: ___________________________________
Page 9: Module description: this module fea

ADK Sensor Kit Shield - TinkerKit Mega Sensor Shield V.2 - Elfa

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?