AN369: Si4010 Antenna Interface and Matching Network ... - wless.ru

More documents

Recommendations

Info

AN369Figure 1. Operation of the High Impedance PAIn this case lower termination impedance has to be used (i.e. RAP
AN369A second important operation mode is when the current magnitude is reduced (e.g. to reduce the power) and thusthe maximum allowed voltage swing is not achieved even if the conjugate complex termination is applied. In thiscase the PA is "current limited". This is the typical case when the Si4010 chip works in a strongly reduced powerstate or when the internal capacitance bank state is high (close to maximum at low bands and above ~100 in highbands). In this operation mode the optimum termination is the complex conjugate.A third, non-optimum mode is when the current is maximum, but the termination impedance is so low that themaximum swing is not achieved. In this case the termination is not the optimum, and the power and efficiency islower than the possible maximum.Table 1. SOIC Maximum Power OperationFreq [MHz]SOICOpt. loadimp. []Opt. loadadm.[mSie]Parallel Eqv.R AP[]Parallel Eqv.L AP[nH]Cap. bankstate & TXequivalentcapacitance(CTX)Power to thedifferentialload [dBm]315 TBD TBD TBD TBD TBD TBD434 34.13+j123.36 2.08–j7.53 480 48.7 19; 2.76pF 10.7868 8.07+j57.64 2.38–j17.02 420 10.8 17; 3.12pF 9.4915 TBD TBD TBD TBD TBD TBDTable 2. MSOP Maximum Power OperationFreq [MHz]MSOPOpt. loadimp. []Opt. loadadm.[mSie]Parallel Eqv.R AP[]Parallel Eqv.L AP[nH]Cap. bankstate & TXequivalentcapacitancePower to thedifferentialload [dBm]315 TBD TBD TBD TBD TBD TBD434 33.8+j126.8 1.96–j7.36 510 49.8 19; 2.70pF 10.8868 8.9+j68.1 1.89–j14.44 530 12.7 9; 2.65pF 9.85915 TBD TBD TBD TBD TBD TBD3. Inductively Tapped Loop Antenna Design Example3.1. Antenna Dimensions and Measured Data with Si4010-A0-GS Engineering VersionThis antenna design uses the Si4010-A0-GS version of the Si4010 chip. The designed antenna top layout with finalouter dimensions is shown in Figure 2. The bottom layout is shown in Figure 3. The schematic is shown inFigure 4. The manufacturing pack (including CAM/CAD/PDF files and the BOM) is available at www.silabs.com.The whole unit is encapsulated by the Polycase FB-20 plastic enclosure as shown in Figures 5–7.Rev. 0.1 3
Page 1: AN369Si4010 ANTENNA I NTERFACE AND
Page 5 and 6: AN369Figure 4. 4010-DAPB434 Schemat
Page 7 and 8: AN369Figure 5. Si4010-DAPB434 Key F
Page 9 and 10: AN369Figure 8. Antenna Simulation (
Page 11 and 12: AN369enough to accurately estimate
Page 13 and 14: AN369Simulated impedance:The simula
Page 15 and 16: AN3694.1. Matching Baluns for Si401
Page 17 and 18: AN3694.1.2. 868MHz SOIC Matching Ba
Page 19 and 20: AN3694.1.3. 434 MHz MSOP Matching B
Page 21 and 22: AN369Figure 21. Measured Spectrum U
Page 23 and 24: AN3694.2. High Q Discrete Matching
Page 25 and 26: AN3691. Calculate the values e.g. f
Page 27 and 28: AN3694.00180.0PHASE3.0090.002.000.0

AN369: Si4010 Antenna Interface and Matching Network ... - wless.ru

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?