S type - Kitagawa Europe

DATE 18 DEC 2008 № MA0534RKY P24The resolution / an assembling work procedureFor S type cylinderMANAGER CHIEF WRITE BY高 橋 優SleeveFig. 5Rotary valve6 ) It makes as shown in Fig. 3, and the sleeve body F are removed. Afterwards, please make thecylinder as shown in Fig. 4 and give an upper and lower impact slightly.The sleeve G is removed, it falls, and it is resoluble as shown in figure on the this page. (Fig. 5)7 ) Socket head cap screw 03 12 pieces or 16 pieces are loosened, the cylinder D is removed byusing the tap for pulling out (Fig. 7) that exists in the rotary valve E and the piston H is pulledout. At this time, please be suitable for the cylinder and rotary valve in the marker etc. and fill in themark. It divides into the rotary valve E , the piston H , and the cylinder D . (Please note that thehydraulic enclosed in the cylinder this time flows out.)(Fig. 6 and 8)It is resolution completion in this.Fig. 6 Fig. 7KITAGAWA IRON WORKS CO., LTD.