S type - Kitagawa Europe

DATE 18 DEC 2008 № MA0534RKY P44The resolution / an assembling work procedureFor S type cylinder11 ) The cylinder is unloaded from the spindle, and thesleeve is inserted from the rear side of rotary valveE . It enters smoothly when doing while lightlybeating with the hammer etc. with a ring form specialjig in a right picture. At this time, please build it innoting that the sleeve doesn't twist. (Fig. 11)MANAGER CHIEF WRITE BY高 橋 優12 ) Flinger N is inserted in rotary valve E . Afterwards,please arrange the plug insertion hole and thedirection of the sleeve G and build in the sleeve bodyF .13 ) The plug L is wrung. (Fig. 2)14 ) The stopper L is installed with the socket head capscrew 02 . (Please insert S2091 or more withoutforgetting sheat-packing (C).)(Fig. 1)15 ) The fan K and fan-cover J are obtained with aCross-recessed head machine screw 14 、20 . (Fig. 1)16 ) After assembly, the cylinder is installed in the spindleaccording to the above-mentioned procedure.Afterwards, please adjust it so that run-out at theinstallation may become 0.015TIR or less by outer ofrotary valve E and 0.01TIR or less by outer ofsleeve body F .Fig. 1117 ) Please use it after laying pipes after assembly iscompleted and confirming operation.Notes of assembly・ When O-ring and the oil seal are damaged, it causes the oil leakage. Therefore, please assemble itmight not spread oil enough on the sliding area and each part O-ring, and to damage it.・ At assembly, When garbage etc. enter in the cylinder it causes overheating. Please assemble itvery carefully.KITAGAWA IRON WORKS CO., LTD.