S type - Kitagawa Europe

More documents

Recommendations

Info

DATE 18 DEC 2008 № MA0534RKY P34The resolution / an assembling work procedureFor S <strong>type</strong> cylinderMANAGER CHIEF WRITE BY高橋優Fig. 8The assembly work procedure is shown here.8 ) The position H of guide-pin Q 2 pieces is matchedand the piston is built into the rotary-valve E .(Fig. 7)9 ) O-ring 04 is built into the cylinder D . The piston Hand rotary valve E are inserted in the cylinder D , itmatches, the position with the plug S in outer of O-ring04 and rotary valve E is built, and it tightens with thesocket head cap screw 03 lightly.(Please be suitable and confirm it by the mark.)(Fig. 6and 9)10 ) Under such a condition, please install it in the spindleonce. And, please do the wick match so that run-out ofthe cylinder D and rotary valve E may become smallas much as possible. Afterwards, please tighten with thesocket head cap screw 03 .(run-out must aim at 0.01TIR or less.)(Fig. 10)Fig. 9Fig. 10KITAGAWA IRON WORKS CO., LTD.
DATE 18 DEC 2008 № MA0534RKY P44The resolution / an assembling work procedureFor S <strong>type</strong> cylinder11 ) The cylinder is unloaded from the spindle, and thesleeve is inserted from the rear side of rotary valveE . It enters smoothly when doing while lightlybeating with the hammer etc. with a ring form specialjig in a right picture. At this time, please build it innoting that the sleeve doesn't twist. (Fig. 11)MANAGER CHIEF WRITE BY高橋優12 ) Flinger N is inserted in rotary valve E . Afterwards,please arrange the plug insertion hole and thedirection of the sleeve G and build in the sleeve bodyF .13 ) The plug L is wrung. (Fig. 2)14 ) The stopper L is installed with the socket head capscrew 02 . (Please insert S2091 or more withoutforgetting sheat-packing (C).)(Fig. 1)15 ) The fan K and fan-cover J are obtained with aCross-recessed head machine screw 14 、20 . (Fig. 1)16 ) After assembly, the cylinder is installed in the spindleaccording to the above-mentioned procedure.Afterwards, please adjust it so that run-out at theinstallation may become 0.015TIR or less by outer ofrotary valve E and 0.01TIR or less by outer ofsleeve body F .Fig. 1117 ) Please use it after laying pipes after assembly iscompleted and confirming operation.Notes of assembly・ When O-ring and the oil seal are damaged, it causes the oil leakage. Therefore, please assemble itmight not spread oil enough on the sliding area and each part O-ring, and to damage it.・ At assembly, When garbage etc. enter in the cylinder it causes overheating. Please assemble itvery carefully.KITAGAWA IRON WORKS CO., LTD.
Page 1 and 2: The resolution / an assemblingwork
Page 3: DATE 18 DEC 2008 № MA0534RKY P24T

S type - Kitagawa Europe

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?